Ford Racing 4.6L 3-VALVE PERFORMANCE INTAKE MANIFOLD - 2005-2010 Mustang GT

• Fits 2005-2010 4.6-Liter 3-Valve Mustang engines.
• Works well with Ford Racing''s M-6550-3V hot rod camshafts, M-6049-N3VPA high performance CNC ported 3-Valve Cylinder Heads and Ford Racing's M-9926-3V 62mm throttle body.
• Lightweight composite construction (same material as OE intake manifold)
• Less heat soak than aluminum intakes
• High-flow runners and open plenum design, fits under factory Mustang hood.
• MAP sensor mounting boss for speed-density applications
• Includes Intake Manifold Gaskets
• Calibration required! Calibration not included!
• Does not fit with Ford Racing strut tower braces

NOTE: Throttle body not included.

In the September 2010 issue of Muscle Mustangs and Fast Fords, the editors made big power numbers with the intake, hot rod 3V cams and CNC ported cylinder heads. Visit the MM&FF website for an install article on this new intake.

The M-9424-463V 4.6L 3-Valve Performance Intake Manifold normally shows flexing of the manifold body during normal operation with some fuel rail movement. Our testing shows this flexing will not lead to premature failure of the manifold, injector or injector gasket. Ford Racing will replace any M-9424-463V 4.6L 3-Valve Performance Intake Manifold that fails due to defects in workmanship or materials within three (3) years of the date of purchase. Proof of purchase will be required for submission of warranty claim. To the extent allowed by law, this warranty does not cover towing, shipping, removal, installation, rental vehicles, storage, loss of time, commercial loss, loss of use of vehicle, inconvenience, incidental or consequential damages, or other economic loss. Contact the Ford Performance Call Center at (800)367-3788 for details. Damage as a result of improper tuning is not covered.